Our patented Side Post Battery Disconnect switch is designed to be used with General Motors style batteries with the connections on the side. A simple twist of a knob provides a convenient way to quickly disconnect and reconnect…
Fully Automatic - Will keep your battery fully charged without over charging. The on-board microprocessor turns the charger on and off based on your battery's demands. It does so automatically, every few milliseconds.
Designed…
Original and reproduction battery trays. All of our battery trays are made of stamped steel and are painted factory black. Battery bolts are sold separately.
…
Original and reproduction battery trays. All of our battery trays are made of stamped steel and are painted factory black. Battery bolts are sold separately.
…
Attach this to the battery post and when you leave the car, unscrew the knob. It is a good safety item that disconnects electrical current, eliminating theft, battery drain and fires.
…
Conveniently charge/maintain your vehicle's battery through the cigarette lighter or power plug port. Fuse protected with 12" cord. Connects to Battery Butler Storage Charger (BBFC100 & BBFC200). ****Adapter should only be used in a…
Repair rusty inner fender aprons with our new die stamped sheet metal panels. These are the sheet metal panel that sits below your battery tray. These are the section below and around your battery. Cut out the old and weld in the new…
Correct stamped steel battery tray hold down bracket for 1960/1966 models of Ranchero, Falcon and Comet with 40 and 45 amp batteries. Made to match the original Ford part exactly and finished in original semi-gloss black paint.
…
All terminals, boots, heads and mouldings have been duplicated with exacting details. The wire insulation is original neoprene rubber. The set includes positive, negative and starter cables. 1965 - 1969 cars also used a separate…
1965 - 1969 cars used a separate ground strap that was used at the back of the engine head. 1970 and newer vehicles do not require this as a grounding tab is built into the negative cable.
…
1965 - 1969 cars used a separate ground strap that was used at the back of the engine head. 1970 and newer vehicles do not require this as a grounding tab is built into the negative cable.
…
Avoid Short Circuits & Battery Drain Fools Thieves Just twist the handy knob and cut off current at the battery. Simple switch installs in minutes and easily removes to return to original condition. Purchase jumper wire (P/N 88-0337-1)…
Sized to secure a Group 27 battery in the engine bayReplaces a weakened or corroded battery tray to restore original appearance and functionalityMade from stamped steel with a black paint finishOE-Correct reproduction for easy bolt-in…
Universal Fit, 6" Overall Length, Aluminum
Lightweight aluminum construction
5" center to center holes
6" long
Sold Individually
Terminal holes have a center to center diameter of 3"
…
The Exile EM-1 LED battery monitor will tell you your battery’s charge status at a glance. The EM-1 has a three-stage LED readout, and can be left attached to your car battery. If your battery is low, simply plug your Exile EX-1 battery…
Exactly like the originals. These battery trays are a popular item for restorers since most of the originals have been destroyed by leaking batteries over the years.
…
This battery top cover looks great under the hood at car shows and is designed to give your Mustang its original look back. The cover fits over the top of any Group 24 top-post battery and is made of high-quality plastic for long-lasting…